Prophet River Firearms

Mounting Hardware is Included

This product fits:
Howa/Vanguard short action calibers
.223 Rem.
22-250 Rem.
.243 Win.
6.5 Creedmoor
7MM Rem. Mag.
308 Win

Machined From: Solid 4140 Steel
Finish: Parkerized
Center Spread: 3.886"
Overall Length of Mount: 6.670"
Height: .35" (Top of Receiver to Top of Picatinny)
Weight: 5.6 oz
Quick Disconnect Ring Compatible: Yes
Ambidextrous: Yes
Compatible with Picatinny or Weaver scope rings.
Mounting Hardware: #6-48 X 1/4 Screws and T-10 Bit Included
Torque Specs: 20 in/lbs

Are you looking to mount a scope to your Weatherby Vanguard? These mounts sit at about .35" high. Measurements may vary depending if the firearm has a stepped receiver. Our .35" measurement is typically from the highest point on the receiver.

Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The cross slots are also machined the full width of the mount and gauged to MIL-STD 1913 specs maintaining tolerances of +/-.002".

After machining; the mounts are sand blasted. The steel rails are Mil Spec parkerized for a durable rust resistant finish.

Compatible with Picatinny or Weaver scope rings. Add our HD Scope Rings to make it a complete package!

From manufacturing to packaging, our products are made with pride in the USA.

We recommend:
0 MOA -if shooting 0-500 yards
20 MOA -if shooting 500-1000 yards

When zeroing your rifle with a 20 MOA mount, we recommend zeroing at 200 yards.

Installation: EGW recommends 20 inch lbs of torque and a drip of blue loctite.