Prophet River Firearms

To install the accessory cage, remove the lens cap from the eyepiece and slide the cage over the eyepiece with the horseshoe opening facing forward toward the objective. The accessory cage will slide on and fit between the body tube and the integrated base.

On the bottom, align the 6 holes of the cage with the corresponding holes on the integrated base and lightly secure a screw on either side to hold the cage in place. Continue to place screws in the other holes and tighten until they are flush with the base but not torqued to spec. Once all are in place, gradually tighten the screws to 35 in-lb using the tightening sequence shown to the left. If no torque driver is available, tighten 1/8 turn past initial resistance using the provided hex wrench.

NOTE: If the CFS 6-36 is purchased as a kit, the accessory cage will come installed from the factory. The M-LOK® picatinny rails can be installed by the user.