Prophet River Firearms

Mounting Hardware is Included

This mount fits:
Ruger 10/22
Ruger 10/22 Takedown

We have changed our mount and no longer make it as a 10 MOA. All mounts produced after 9/2020 are 0 MOA.

This scope mount will fit the 10-22, 10-22 takedown and is lowered to allow for use of rear sight with mount mounted on the models with the flip up rear sight. We have found you may not be able to see the rear sight on the models that have the adjustable rear sight.

We recommend measuring the hole spacing in your receiver to confirm it matches with the dimensions we have published.

Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount. Also, in many cases, it will not obstruct usage of factory iron sights. Our one-piece scope mounts are the obvious choice for hunters and tactical shooters alike.

We machine these in our shop using one of our machining centers. After machining, the mounts are tumbled, sand blasted, and Type II anodized for long lasting durability.

Installation: We recommend 20 inch lbs of torque and a drip of blue loctite.

We recommend:
0 MOA - if shooting 0-150 yards
20 MOA - if shooting 150-300 yards

The entire mount and accessories (from the mounting screws and wrench down to the packaging) are made in the USA.

Rail Type: One Piece Picatinny
Machined from: Domestic 6061 T6 Extruded Aluminum
Finish: Matte Black Anodizing
Center Spread: 2.57"
Overall Length: 4.645"
Height: .3" (Top of Receiver to Top of Picatinny)
Weight: 2 oz.
Quick Disconnect Ring Compatible: No
Ambidextrous: Yes
Torque Specs: 20 in/lbs
Mounting Hardware: #6-48 X 1/4 Screws and T-10 Bit Included